I am using Ubunut Precise (12.04 LTS) in VMWare (for months)
I had Erlang R14B04 installed.
I used the commands (below) to install R15B
everything went fine, but when I run erl at the command prompt, I get the R14B04 shell
I cannot locate the activate command (listed on another post)
How do I set erl to the new R15 version ?
The commands I used were:
apt-get -y install build-essential m4 libncurses5-dev libssh-dev unixodbc-dev libgmp3-dev libwxgtk2.8-dev libglu1-mesa-dev fop xsltproc default-jdk
mkdir -p /src/erlang
cd /src/erlang
wget http://www.erlang.org/download/otp_src_R15B.tar.gz
tar -xvzf otp_src_R15B.tar.gz
chmod -R 777 otp_src_R15B
cd otp_src_R15B
./configure
make
make install
NOTE: I used sudo where appropriate and I got no install errors!!
Bookmarks