I just upgraded Ubuntu to 12.10 64 bit and as part of the upgrade I install Fldigi. My problem is that when I try to set up my rig I get the following error - hamlib_init: IO error. It doesn't seem to matter how I set it up.
I have used Fldigi in the past and have had it working flawlessly with previous versions of Fldigi and Ubuntu.
My radio is a Yaesu Ft-897d and I am using a USB cable, not a USB to serial adaptor. This is the very same cable that I have used in the past with previous software versions.
Bus 001 Device 003: ID 0409:0058 NEC Corp. HighSpeed Hub
Bus 002 Device 002: ID 046d:0a01 Logitech, Inc. USB Headset
Bus 002 Device 003: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port
Bus 002 Device 004: ID 046d:c517 Logitech, Inc. LX710 Cordless Desktop Laser
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 006: ID 1058:1102 Western Digital Technologies, Inc.
I think the cable that the radio is on is the one labeled Prolific etc... It is connected directly to the back of the computer and not through a hub.
I have checked the connection and even after re-connecting in a different usb port it isn't recognized.
Here is the output that I get when I run fldigi from command line. I know there are a number of errors relating to audio devices. I am fairly certain this isn't the problem.
I don't remember what I did but I was able to get fldigi to at least read the current frequency a day or so ago. Unfortunately, whatever I did didn't stick and I am stuck at square one again.
Any hams out there with a similar experience or a solution?
Any ideas are appreciated.