Hi there,

I had The Perfect test setup running, using a laptop with the Ethernet connection to a test board using a manually set ip adrdress, while at the same time the WiFi connection was using DHCP for internet, Dropbox.

After i reinstall I could not go back to this ideal situation, because the default ip is directed to the wired connection.

Here's the route table with wifi only:
Code:
anders@anders-HP-635-Notebook-PC ~/Desktop $ route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default         192.168.0.1     0.0.0.0         UG    0      0        0 wlan0
link-local      *               255.255.0.0     U     1000   0        0 wlan0
192.168.0.0     *               255.255.255.0   U     2      0        0 wlan0
And here is the same with wired connectio also:
Code:
anders@anders-HP-635-Notebook-PC ~/Desktop $ route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default         172.16.0.1      0.0.0.0         UG    0      0        0 eth0
link-local      *               255.255.0.0     U     1000   0        0 wlan0
172.16.0.0      *               255.255.0.0     U     1      0        0 eth0
192.168.0.0     *               255.255.255.0   U     2      0        0 wlan0
I have tried to read "man route", but I am not sure I understand what to do. I would prefer 192.168.0.1 to be the default also with both active.