Hello,
I assembled a new PC (P8Z77-I Ivy Bridge motherboard).
I ran sensors detect but the only thing I get with sensors is:
Code:
pmatos@jupiter:~$ sensors
acpitz-virtual-0
Adapter: Virtual device
temp1: +27.8°C (crit = +106.0°C)
temp2: +29.8°C (crit = +106.0°C)
coretemp-isa-0000
Adapter: ISA adapter
Physical id 0: +38.0°C (high = +85.0°C, crit = +105.0°C)
Core 0: +32.0°C (high = +85.0°C, crit = +105.0°C)
Core 1: +33.0°C (high = +85.0°C, crit = +105.0°C)
Core 2: +25.0°C (high = +85.0°C, crit = +105.0°C)
Core 3: +33.0°C (high = +85.0°C, crit = +105.0°C)
Fans are currently running at a very high speed (quite noisy).
I want them to control themselves so that they only turn on when they see fit.
I noticed the following using dmesg:
Code:
[ 0.826817] ACPI: Fan [FAN0] (off)
[ 0.826834] ACPI: Fan [FAN1] (off)
[ 0.826851] ACPI: Fan [FAN2] (off)
[ 0.826867] ACPI: Fan [FAN3] (off)
[ 0.826882] ACPI: Fan [FAN4] (off)
I am wondering if this is affecting sensors detect ability to see the fans and show their speed (at the same time allowing the kernel to set fan speeds as it sees fit).
Any suggestions?
Bookmarks