My sensors' output:
Code:
w83627hf-isa-0290
Adapter: ISA adapter
in0: +1.44 V (min = +2.99 V, max = +3.39 V) ALARM
in1: +1.46 V (min = +2.99 V, max = +3.39 V) ALARM
in2: +3.36 V (min = +2.82 V, max = +3.79 V)
in3: +2.99 V (min = +0.13 V, max = +1.55 V) ALARM
in4: +3.23 V (min = +0.34 V, max = +0.02 V) ALARM
in5: +3.23 V (min = +0.34 V, max = +2.18 V) ALARM
in6: +3.23 V (min = +1.55 V, max = +0.19 V) ALARM
in7: +3.36 V (min = +2.06 V, max = +0.35 V) ALARM
in8: +3.49 V (min = +0.13 V, max = +1.02 V) ALARM
fan1: 0 RPM (min = 8437 RPM, div = 8) ALARM
fan2: 2220 RPM (min = 3515 RPM, div = 8) ALARM
fan3: 0 RPM (min = 10546 RPM, div = 2) ALARM
temp1: +31.0°C (high = +40.0°C, hyst = -121.0°C) sensor = thermistor
temp2: +48.0°C (high = +80.0°C, hyst = +75.0°C) sensor = diode
temp3: +67.5°C (high = +80.0°C, hyst = +75.0°C) sensor = thermistor
cpu0_vid: +1.388 V
beep_enable: enabled
I use this line in my conky
Code:
${execi 60 sensors|grep temp2|cut -c 14-21}
to get the temp2 (cpu) temperature.
The line executes sensors every 60 seconds, filters the output to show only the line with the string temp2 in it (grep) and then takes the characters between the 14th and the 21rst (+48.0°C) and prints them on conky.
I don't think it's too difficult to adjust it to your needs.
Bookmarks