I recently updated to Elementary OS 0.2 and after the update my wireless just cut out and doesn't show anymore. I have an HP Pavilion g7.
says:Code:sudo lspci
00:00.0 Host bridge: Intel Corporation Ivy Bridge DRAM Controller (rev 09)
00:02.0 VGA compatible controller: Intel Corporation Ivy Bridge Graphics Controller (rev 09)
00:14.0 USB controller: Intel Corporation Panther Point USB xHCI Host Controller (rev 04)
00:16.0 Communication controller: Intel Corporation Panther Point MEI Controller #1 (rev 04)
00:1a.0 USB controller: Intel Corporation Panther Point USB Enhanced Host Controller #2 (rev 04)
00:1b.0 Audio device: Intel Corporation Panther Point High Definition Audio Controller (rev 04)
00:1c.0 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 1 (rev c4)
00:1c.1 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 2 (rev c4)
00:1c.2 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 3 (rev c4)
00:1d.0 USB controller: Intel Corporation Panther Point USB Enhanced Host Controller #1 (rev 04)
00:1f.0 ISA bridge: Intel Corporation Panther Point LPC Controller (rev 04)
00:1f.2 SATA controller: Intel Corporation Panther Point 6 port SATA Controller [AHCI mode] (rev 04)
00:1f.3 SMBus: Intel Corporation Panther Point SMBus Controller (rev 04)
01:00.0 Network controller: Ralink corp. Device 3290
01:00.1 Bluetooth: Ralink corp. Device 3298
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 05)
03:00.0 Unassigned class [ff00]: Realtek Semiconductor Co., Ltd. Device 5229 (rev 01)
says:Code:sudo lsusb
Bus 001 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
Bus 002 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub
Bus 003 Device 002: ID 046d:c52f Logitech, Inc. Wireless Mouse M305
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 002 Device 003: ID 1bcf:2c1e Sunplus Innovation Technology Inc.
says:Code:ifconfig
eth0 Link encap:Ethernet HWaddr 84:34:97:6e:9d:9f
inet addr:192.168.1.217 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::8634:97ff:fe6e:9d9f/64 Scope:Link
inet6 addr: 2602:306:32e2:820:2116:1a0b:de8c:9910/64 Scope:Global
inet6 addr: 2602:306:32e2:820:8634:97ff:fe6e:9d9f/64 Scope:Global
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3792 errors:0 dropped:0 overruns:0 frame:0
TX packets:2872 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3029131 (3.0 MB) TX bytes:415785 (415.7 KB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:908 errors:0 dropped:0 overruns:0 frame:0
TX packets:908 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:80427 (80.4 KB) TX bytes:80427 (80.4 KB)
says:Code:sudo lshw -C network
*-network UNCLAIMED
description: Network controller
product: Ralink corp.
vendor: Ralink corp.
physical id: 0
bus info: pci@0000:01:00.0
version: 00
width: 32 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list
configuration: latency=0
resources: memory:c2510000-c251ffff
*-network
description: Ethernet interface
product: RTL8101E/RTL8102E PCI Express Fast Ethernet controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:02:00.0
logical name: eth0
version: 05
serial: 84:34:97:6e:9d:9f
size: 100Mbit/s
capacity: 100Mbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full firmware=rtl_nic/rtl8105e-1.fw ip=192.168.1.217 latency=0 link=yes multicast=yes port=MII speed=100Mbit/s
resources: irq:42 ioport:3000(size=256) memory:c2404000-c2404fff memory:c2400000-c2403fff
says:Code:iwconfig
eth0 no wireless extensions.
lo no wireless extensions.
I figured it was my wireless driver, so I followed the tutorial here:but after I restarted still nothing happened. In my network center it doesn't show any network connections. Please, any help is much appreciated.HTML Code:http://forum.novatech.co.uk/showthread.php?25562-How-to-get-the-RAlink-3290-wireless-working
Bookmarks