i did lsusb in the terminal window, and i got:
Bus 001 Device 002: ID 1737:0071 Linksys WUSB600N Dual-Band Wireless-N USB Network Adaptor.
i did lsusb in the terminal window, and i got:
Bus 001 Device 002: ID 1737:0071 Linksys WUSB600N Dual-Band Wireless-N USB Network Adaptor.
I am also trying to bring up wusb600nv2[rt3572sta driver] card in monitor mode. I was able to set monitor mode for interfaces via iwconfig/iw utility.iwconfig returns that the interface is in Monitor mode. But the rx packets counters are not increasing + coulcdn't find any packets on the sniffer(wireshark). Anybody seen this issue before? Btw i am using ubuntu 11.04 64bit.
ra0 Ralink STA ESSID:"" Nickname:"RT3572STA"
Mode:Monitor Frequency=2.412 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s
RTS thrff Fragment thrff
Link Quality=10/100 Signal level:0 dBm Noise level:0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
wlan0 IEEE 802.11abgn Mode:Monitor Tx-Power=19 dBm
Retry long limit:7 RTS thrff Fragment thrff
Power Managementff
Thanx in Adv,
Jithu Jance.
Bookmarks