I have a problem with my wireless where when running the laptop from the battery the connection is very slow. When the laptop is connected to the power supply everything is fine, but the moment it's disconnected and run on the battery the speed drops when browsing the Internet or accessing files on other computers on my network
The laptop is a Samsung SF310
Wireless chipset is BCM4313
Code:
02:00.0 Network controller: Broadcom Corporation BCM4313 802.11b/g LP-PHY (rev 01)
Subsystem: Wistron NeWeb Corp. Device 051a
Flags: bus master, fast devsel, latency 0, IRQ 16
Memory at f4c00000 (64-bit, non-prefetchable) [size=16K]
Capabilities: <access denied>
Kernel driver in use: wl
Kernel modules: wl
In attempt to fix this I installed the latest drivers from the Broadcom site using this guide
When I enabled these drivers everything worked well. I did speed test and got the same speeds I get when connected via Ethernet:
Ping 51ms
DL 4.31
UL 0.65
So I set the drivers to load at boot using this forum post as a guide as the steps in the Broadcom guide didn't work and rebooted the laptop on battery power. The wireless connected fine, but the slow speed problem had returned. Running a speed test got the following results
Ping 235
DL 0.54
UL 0.30
So I ran iwconfig when running from battery and then from power supply.
Code:
xxxx@xxxx ~ $ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11 Access Point: Not-Associated
Link Quality:5 Signal level:215 Noise level:160
Rx invalid nwid:0 invalid crypt:0 invalid misc:0
As can be seen the signal quality is 5 and signal level 215
Code:
xxxx@xxxx ~ $ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11 Access Point: Not-Associated
Link Quality:5 Signal level:214 Noise level:164
Rx invalid nwid:0 invalid crypt:0 invalid misc:0
And when connected via the power supply the signal level is 5 and signal level 214.
There may be some kind of power saving issue, although there are no relevant setting in the BIOS and I can't see anything in the various wireless control pannels. I have other wireless drivers and there are no problem with those.
Anyone got any ideas what's causing this?
Bookmarks