Hi everyone,
I have just got my asus eeepc 1201n works on ubuntu 9.1. The wireless driver rthl8192_pci works well up to now. But there is a problem that it always flood many message in my kernel log (dmesg). Is there anyway to suppress / close the message output of rtl8192_pci? here is a sample output of the message I saw:
Code:
[ 204.978056] ===>ieee80211_associate_procedure_wq(), chan:11
[ 204.978066] ==========>HTSetConnectBwMode():pHTInfo->bCurBW40MHz:0
[ 204.988061] =================>ieee80211_authentication_req():auth->algorithm is 0
[ 204.989971] ===>rtl8192_SetWirelessMode(), wireless_mode:0x6, support_mode:0x16
[ 204.989985] <===rtl8192_SetWirelessMode(), wireless_mode:4, bEnableHT = 0
[ 204.992426] #################ieee80211_sta_send_associnfo(), assocreq_ies_len:24,assocresp_ies_len:24
[ 204.993939] Associated successfully
[ 204.993955] ============>normal associate
[ 204.993988] Using G rates:108
[ 204.993994] Successfully associated, ht not enabled(0, 0)
[ 204.994029] ===========rtl8192se_update_ratr_table: ff5
[ 204.994036] ===>set to B/G mode
[ 205.007676] ===>u4bAcParam:731c, ===>u4bAcParam:731c, ===>u4bAcParam:731c, ===>u4bAcParam:731c, ===>DHCP Protocol start tx DHCP pkt src port:68, dest port:67!!
[ 255.746083] ===========rtl8192se_update_ratr_table: ff5
[ 255.746091] ===>set to B/G mode
[ 295.742086] ===========rtl8192se_update_ratr_table: ff5
[ 295.742094] ===>set to B/G mode
[ 355.754077] ===========rtl8192se_update_ratr_table: ff5
[ 355.754084] ===>set to B/G mode
[ 435.758041] ===========rtl8192se_update_ratr_table: ff5
[ 435.758048] ===>set to B/G mode
[ 535.750038] ===========rtl8192se_update_ratr_table: ff5
[ 535.750045] ===>set to B/G mode
[ 655.738083] ===========rtl8192se_update_ratr_table: ff5
[ 655.738090] ===>set to B/G mode
[ 775.754035] ===========rtl8192se_update_ratr_table: ff5
[ 775.754042] ===>set to B/G mode
[ 895.750129] ===========rtl8192se_update_ratr_table: ff5
[ 895.750137] ===>set to B/G mode
[ 1015.750054] ===========rtl8192se_update_ratr_table: ff5
[ 1015.750062] ===>set to B/G mode
[ 1135.754030] ===========rtl8192se_update_ratr_table: ff5
[ 1135.754037] ===>set to B/G mode
I am running kernel 2.6.31-18-generic and install the driver by following the guide here:
http://ubuntuforums.org/showthread.php?t=1354666&page=2
Thank you very much.
Best regards.
WONG Hang.
Bookmarks