I just followed THIS HOWTO to make Skype (only) not use PulseAudio and it works like a charm...
The only difference is that in the part where You have to comment out load-module module-hal-detect You have to do it like this:
Change this:
Code:
### Automatically load driver modules depending on the hardware available
.ifexists module-hal-detect.so
load-module module-hal-detect tsched=0
.else
### Alternatively use the static hardware detection module (for systems that
### lack HAL support)
load-module module-detect
.endif
to this:
Code:
### Automatically load driver modules depending on the hardware available
#.ifexists module-hal-detect.so
#load-module module-hal-detect tsched=0
#.else
### Alternatively use the static hardware detection module (for systems that
### lack HAL support)
#load-module module-detect
#.endif
(Comment out the whole section and not just the load-module module-hal-detect part)
Works for me...
Remember to select skypein as your input device and skypeout as your ringing and output device in Skype...
Thanks go to Berkus for sending me the link to the above guide...
Bookmarks