Hi all,
See characteristics below.
Can I increase RAM memory or is it full already?
Code:
# dmidecode 2.12
SMBIOS 2.4 present.
Handle 0x0005, DMI type 5, 20 bytes
Memory Controller Information
Error Detecting Method: 64-bit ECC
Error Correcting Capabilities:
None
Supported Interleave: One-way Interleave
Current Interleave: One-way Interleave
Maximum Memory Module Size: 1024 MB
Maximum Total Memory Size: 2048 MB
Supported Speeds:
70 ns
60 ns
Supported Memory Types:
Standard
EDO
Memory Module Voltage: 3.3 V
Associated Memory Slots: 2
0x0006
0x0007
Enabled Error Correcting Capabilities:
None
Handle 0x0006, DMI type 6, 12 bytes
Memory Module Information
Socket Designation: A0
Bank Connections: 1
Current Speed: 155 ns
Type: Other Unknown EDO
Installed Size: 1024 MB (Single-bank Connection)
Enabled Size: 1024 MB (Single-bank Connection)
Error Status: OK
Handle 0x0007, DMI type 6, 12 bytes
Memory Module Information
Socket Designation: A1
Bank Connections: 2
Current Speed: 155 ns
Type: Other Unknown EDO
Installed Size: 2048 MB (Double-bank Connection)
Enabled Size: 2048 MB (Double-bank Connection)
Error Status: OK
Handle 0x001F, DMI type 16, 15 bytes
Physical Memory Array
Location: System Board Or Motherboard
Use: System Memory
Error Correction Type: None
Maximum Capacity: 8 GB
Error Information Handle: Not Provided
Number Of Devices: 2
Handle 0x0020, DMI type 17, 27 bytes
Memory Device
Array Handle: 0x001F
Error Information Handle: Not Provided
Total Width: 64 bits
Data Width: 64 bits
Size: 1024 MB
Form Factor: DIMM
Set: None
Locator: A0
Bank Locator: Bank0/1
Type: Unknown
Type Detail: None
Speed: 667 MHz
Manufacturer:
Serial Number:
Asset Tag:
Part Number:
Handle 0x0021, DMI type 17, 27 bytes
Memory Device
Array Handle: 0x001F
Error Information Handle: Not Provided
Total Width: 64 bits
Data Width: 64 bits
Size: 2048 MB
Form Factor: DIMM
Set: None
Locator: A1
Bank Locator: Bank2/3
Type: Unknown
Type Detail: None
Speed: 667 MHz
Manufacturer:
Serial Number:
Asset Tag:
Part Number:
Bookmarks