Adding Videoram is the only action I did as far as I can say.
The output of (II) is the same here, but if I try to put in the xorg option
Videoram 131072
instead of
Videoram 65526
my machine cannot even starts xorg.
My VGA
My /proc/mtrr00:02.0 VGA compatible controller: Intel Corporation 82852/855GM Integrated Graphics Device (rev 02)
Subsystem: Fujitsu Siemens Computers Device 106a
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx+
Latency: 0
Interrupt: pin A routed to IRQ 16
Region 0: Memory at d8000000 (32-bit, prefetchable) [size=128M]
Region 1: Memory at e0380000 (32-bit, non-prefetchable) [size=512K]
Region 2: I/O ports at ec00 [size=8]
Capabilities: <access denied>
Kernel modules: intelfb
reg00: base=0x000000000 ( 0MB), size= 1024MB, count=1: write-back
reg01: base=0x040000000 ( 1024MB), size= 256MB, count=1: write-back
reg02: base=0x050000000 ( 1280MB), size= 128MB, count=1: write-back
reg03: base=0x058000000 ( 1408MB), size= 64MB, count=1: write-back
reg04: base=0x05c000000 ( 1472MB), size= 32MB, count=1: write-back
reg05: base=0x05e000000 ( 1504MB), size= 16MB, count=1: write-back
Bookmarks