Netgear MA521 : Need personal help

[prshah]

 modprobe -r rtl8180
modprobe -r ndiswrapper
modprobe ndiswrapper
/etc/init.d/NetworkManager restart

Instead of all these changes, you should just blacklist the rtl8180 driver;

sudo vi /etc/modprobe.d/blacklist

and add the line

blacklist rtl8180

at the end of the file.

I recommend you undo all your documented changes and do this instead.

[n2stc]

Instead of all these changes, you should just blacklist the rtl8180 driver;

sudo vi /etc/modprobe.d/blacklist

and add the line

blacklist rtl8180

at the end of the file.

I recommend you undo all your documented changes and do this instead.

Thanks, but it doesn't work.

dmesg | tail -50
[   46.373125] Bluetooth: SCO (Voice Link) ver 0.6
[   46.373139] Bluetooth: SCO socket layer initialized
[   46.440434] Bluetooth: RFCOMM socket layer initialized
[   46.441501] Bluetooth: RFCOMM TTY layer initialized
[   46.441700] Bluetooth: RFCOMM ver 1.10
[   48.936843] ACPI: PCI Interrupt Link [LNK0] enabled at IRQ 5
[   48.936876] pci 0000:01:05.0: PCI INT A -> Link[LNK0] -> GSI 5 (level, low) -> IRQ 5
[   49.362862] [drm] Initialized drm 1.1.0 20060810
[   49.395764] [drm] Initialized radeon 1.29.0 20080528 on minor 0
[   50.179578] agpgart-ati 0000:00:00.0: AGP 2.0 bridge
[   50.179639] agpgart-ati 0000:00:00.0: putting AGP V2 device into 4x mode
[   50.179699] pci 0000:01:05.0: putting AGP V2 device into 4x mode
[   50.412462] [drm] Setting GART location based on new memory map
[   50.412489] [drm] Loading R100 Microcode
[   50.412541] [drm] writeback test succeeded in 1 usecs
[   50.661821] eth0: link down
[   51.279147] ndiswrapper version 1.53 loaded (smp=yes, preempt=no)
[   51.419543] ndiswrapper: driver net8180 (Realtek,10/07/2004,5.173.1007.2004) loaded
[   51.423954] ndiswrapper 0000:02:00.0: enabling device (0000 -> 0003)
[   51.423983] ndiswrapper 0000:02:00.0: PCI INT A -> Link[LNK2] -> GSI 10 (level, low) -> IRQ 10
[   51.424854] ndiswrapper 0000:02:00.0: setting latency timer to 64
[   51.552348] ndiswrapper: using IRQ 10
[   51.636464] input: ImPS/2 Synaptics TouchPad as /devices/platform/i8042/serio1/input/input10
[   51.876506] wlan0: ethernet device 00:09:5b:21:a6:b6 using NDIS driver: net8180, version: 0x500aa, NDIS version: 0x500, vendor: 'Realtek RTL8180 Wireless LAN (Mini-)PCI NIC                                     ', 10EC:8180.5.conf
[   51.878015] wlan0: encryption modes supported: WEP; TKIP with WPA; AES/CCMP with WPA
[   51.878657] usbcore: registered new interface driver ndiswrapper
[   57.265083] eth0: link down
[   57.480773] NET: Registered protocol family 17
[   92.586237] NET: Registered protocol family 10
[   92.592813] lo: Disabled Privacy Extensions
[   92.594897] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   92.596706] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   95.349988] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  105.572079] wlan0: no IPv6 routers present
[  184.031586] type=1503 audit(1240883385.847:5): operation="inode_permission" requested_mask="r::" denied_mask="r::" fsuid=7 name="/proc/5649/net/" pid=5649 profile="/usr/sbin/cupsd"
[  185.226118] type=1503 audit(1240883387.043:6): operation="inode_permission" requested_mask="r::" denied_mask="r::" fsuid=7 name="/proc/5653/net/" pid=5653 profile="/usr/sbin/cupsd"
[  185.232512] type=1503 audit(1240883387.050:7): operation="socket_create" family="ax25" sock_type="dgram" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.237513] type=1503 audit(1240883387.054:8): operation="socket_create" family="netrom" sock_type="seqpacket" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.237530] type=1503 audit(1240883387.054:9): operation="socket_create" family="rose" sock_type="dgram" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.237540] type=1503 audit(1240883387.054:10): operation="socket_create" family="ipx" sock_type="dgram" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.237548] type=1503 audit(1240883387.054:11): operation="socket_create" family="appletalk" sock_type="dgram" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.237556] type=1503 audit(1240883387.054:12): operation="socket_create" family="econet" sock_type="dgram" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.237564] type=1503 audit(1240883387.054:13): operation="socket_create" family="ash" sock_type="dgram" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.237571] type=1503 audit(1240883387.054:14): operation="socket_create" family="x25" sock_type="seqpacket" protocol=0 pid=5653 profile="/usr/sbin/cupsd"
[  185.620507] ppdev0: registered pardevice
[  185.672138] ppdev0: unregistered pardevice
[  186.132622] ppdev0: registered pardevice
[  186.269962] ppdev0: unregistered pardevice
[  189.212800] ppdev0: registered pardevice
[  189.261180] ppdev0: unregistered pardevice
stan@sc1-3:~$