Hi All,
Have followed various setups for the above pci card and installed the win 2000 drivers as suggested.
Currently I:
can "see neighbour's AP" in wireless networking. but not my own SSID
I have a cable / DSL connection which works to my router (192.168.2.1)
I have the following outputs:

lspci output:
02:05.0 Ethernet controller: Marvell Technology Group Ltd. 88w8335 [Libertas] 802.11b/g Wireless (rev 03)
02:07.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)

kim@linux:~$ iwconfig
lo no wireless extensions.

ham0 no wireless extensions.

wlan0 IEEE 802.11g ESSIDff/any
Mode:Managed Channel:0 Access Point: Not-Associated
Bit Rate:1 Mb/s Sensitivity=-200 dBm
RTS thr=2346 B Fragment thr=2346 B
Power Managementff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

eth0 no wireless extensions.

kim@linux:~$ sudo iwlist wlan0 scan
wlan0 No scan results

kim@linux:~$ sudo lshw -C network
*-network:0
description: Wireless interface
product: 88w8335 [Libertas] 802.11b/g Wireless
vendor: Marvell Technology Group Ltd.
physical id: 5
bus info: pci@0000:02:05.0
logical name: wlan0
version: 03
serial: 00:1e:2a:b5:25:12
width: 32 bits
clock: 66MHz
capabilities: pm bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=ndiswrapper+wg311v3 driverversion=1.57+NETGEAR,02/22/2005,3.1.1.7 latency=64k=no multicast=yes wireless=IEEE 802.11g
resources: irq:20 memory:fddd0000-fdddffff memory:fdde0000-fddeffff
*-network:1
description: Ethernet interface
product: RTL-8139/8139C/8139C+
vendor: Realtek Semiconductor Co., Ltd.
physical id: 7
bus info: pci@0000:02:07.0
logical name: eth0
version: 10
serial: 00:15:58:46:19:98
size: 100Mbit/s
capacity: 100Mbit/s
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=8139too driverversion=0.9.28 duplex=full ip=192.168.2.10 ncy=64 link=yes maxlatency=64 mingnt=32 multicast=yes port=MII speed=100Mbit/s
resources: irq:22 ioport:de00(size=256) memory:fddff000-fddff0ff
*-network
description: Ethernet interface
physical id: 1
logical name: ham0
serial: 7a:79:19:69:b4:65
size: 10Mbit/s
capabilities: ethernet physical
configuration: autonegotiation=off broadcast=yes driver=tun driverversion=1.6 duplex=full firmware=N/A ip=25.105.101 link=yes multicast=yes port=twisted pair speed=10Mbit/s
=====================================
Any help is greatly appreciated.