Search:

Hi,

I'm trying to install Jaunty on my old laptop (Acer Aspire 1355 LC - Aspire 1350 series).

I'm using ubuntu-9.04-desktop-1386.iso, which I've burnt to CD. Booting from the CD gives me the...

pytheas22:

So, I ran the commands you mentioned to download the latest Broadcom STA drivers... I noticed there were some error messages whilst the code was running, so have posted output below for...

pytheas22:

Thanks for your reply.

I ran the sudo iwlist scan command with my Belkin 54g in:



Router is setup the same i.e. 270 mbps and encryption on.

pytheas22:

Hmmm... I'm not entirely familiar with regards to the IEEE 802.11i protocol you refer to... as far as I understand, my DG834N router is N standard, and I have set it to perform at N...

pytheas22:

My router (Netgear DG834N) is set to "Upto 270mbps". Channel is definitely set at 5 (this is the weird thing - when I have my Belkin 54g card in, WICD shows the channel correctly as in...

pytheas22:

OK, so I ran those commands. Changed the Wireless Interface to wlan0 - refreshed and wireless networks displayed. Tried to connect but looking at the status bar of WICD, it never got...

pytheas22,

Thanks again for your time on this - no worries about posting results of the listed commands!

OK, here they are:

Thanks for your reply on this pytheas22. OK, so here is where I'm at now:

As you suggested, I installed the Broadcom STA drivers via the "Hardware Drivers" option. I also installed WCID. With...

EDIT:

I noticed after posting that in the output of dmesg | grep -e ndis -e wlan, it was showing UNKNOWN SYMBOL - this I believe is a symptom of an invalid driver... so, I found an older version...

Hi,

I'm having trouble getting my Netgear WN511B card working...I have been through a lot of the instructions from the post # 1 on this thread trying to work out whats what, but to no avail as...

Hi,

I'm trying to install 8.04 desktop on a Acer 1355 LC laptop.

Boot from CD is fine, and once I select "Install Ubuntu" from the menu, it starts the process. I get to a certain point...

Hi,

been following this guide trying to get xbuntu onto an old Armada 4220t - no facility to change boot sequence.. so, all going well with unetbootin method until i get to the partioning...