[SOLVED] Silicom PXG4U Cannot Recognise all 4 Ethernet ports

I just bought Silicom PXG4U Quad Port Gigabit Ethernet and installed it in a simple PCI slot (The is no PCI-X slot on the motherboard). The system is running Ubuntu Natty 11.04 64bit server and it will only recognize 2/4 ethernet ports.

Anyone know how to possibly solve the problem?

This is the dmesg output of the system boot when load the module:

Code:

[ 2.810786] tg3 0000:04:04.0: phy probe failed, err -19 [ 2.813608] tg3 0000:04:04.0: Problem fetching invariants of chip, aborting [ 2.813632] tg3 0000:04:04.0: PCI INT A disabled [ 2.813655] tg3 0000:04:04.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19 [ 2.932450] tg3 0000:04:04.1: phy probe failed, err -19 [ 2.935374] tg3 0000:04:04.1: Problem fetching invariants of chip, aborting [ 2.935398] tg3 0000:04:04.1: PCI INT B disabled [ 2.935418] tg3 0000:04:06.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 [ 3.101027] tg3 0000:04:06.0: eth1: Tigon3 [partno(BCM95704A6) rev 2100] (PCIX:133MHz:64-bit) MAC address 00:e0:ed:04:bd:6e [ 3.101031] tg3 0000:04:06.0: eth1: attached PHY is 5704 (10/100/1000Base-T Ethernet) (WireSpeed[1]) [ 3.101034] tg3 0000:04:06.0: eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1] [ 3.101037] tg3 0000:04:06.0: eth1: dma_rwctrl[769f4000] dma_mask[64-bit] [ 3.101061] tg3 0000:04:06.1: PCI INT B -> GSI 16 (level, low) -> IRQ 16 [ 3.243735] tg3 0000:04:06.1: eth2: Tigon3 [partno(BCM95704A6) rev 2100] (PCIX:133MHz:64-bit) MAC address 00:e0:ed:04:bd:6f [ 3.243739] tg3 0000:04:06.1: eth2: attached PHY is 5704 (10/100/1000Base-T Ethernet) (WireSpeed[1]) [ 3.243742] tg3 0000:04:06.1: eth2: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1] [ 3.243745] tg3 0000:04:06.1: eth2: dma_rwctrl[769f4000] dma_mask[64-bit]

and this is the lspci -vv output:

Code:

04:04.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10) Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Interrupt: pin A routed to IRQ 20 Region 0: Memory at dfdf0000 (64-bit, non-prefetchable) [size=64K] Capabilities: [40] PCI-X non-bridge device Command: DPERE- ERO+ RBC=512 OST=1 Status: Dev=04:04.0 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz- Capabilities: [48] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME- Capabilities: [50] Vital Product Data pcilib: sysfs_read_vpd: read failed: Connection timed out Not readable Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+ Address: a547a199970e8370 Data: 14d7 Kernel modules: tg3 04:04.1 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10) Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Interrupt: pin B routed to IRQ 19 Region 0: Memory at dfde0000 (64-bit, non-prefetchable) [size=64K] Capabilities: [40] PCI-X non-bridge device Command: DPERE- ERO+ RBC=512 OST=1 Status: Dev=04:04.1 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz- Capabilities: [48] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME- Capabilities: [50] Vital Product Data pcilib: sysfs_read_vpd: read failed: Connection timed out Not readable Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+ Address: 30c48aea3ff5e3d0 Data: 1093 Kernel modules: tg3 04:06.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10) Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 64 (16000ns min), Cache Line Size: 4 bytes Interrupt: pin A routed to IRQ 18 Region 0: Memory at dfdd0000 (64-bit, non-prefetchable) [size=64K] Capabilities: [40] PCI-X non-bridge device Command: DPERE- ERO+ RBC=512 OST=1 Status: Dev=04:06.0 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz- Capabilities: [48] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME- Capabilities: [50] Vital Product Data Product Name: Broadcom NetXtreme Gigabit Ethernet Controller Read-only fields: [PN] Part number: BCM95704A6 [EC] Engineering changes: 106679-15 [SN] Serial number: 0123456789 [MN] Manufacture ID: 31 34 65 34 [RV] Reserved: checksum bad, 26 byte(s) reserved Read/write fields: [YA] Asset tag: XYZ01234567 [RW] Read-write area: 107 byte(s) free End Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+ Address: f9d56e4ebef4a5d4 Data: d7c7 Kernel driver in use: tg3 Kernel modules: tg3 04:06.1 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10) Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 64 (16000ns min), Cache Line Size: 4 bytes Interrupt: pin B routed to IRQ 16 Region 0: Memory at dfdc0000 (64-bit, non-prefetchable) [size=64K] Expansion ROM at <ignored> [disabled] Capabilities: [40] PCI-X non-bridge device Command: DPERE- ERO- RBC=2048 OST=1 Status: Dev=04:06.1 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz- Capabilities: [48] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME- Capabilities: [50] Vital Product Data Product Name: Broadcom NetXtreme Gigabit Ethernet Controller Read-only fields: [PN] Part number: BCM95704A6 [EC] Engineering changes: 106679-15 [SN] Serial number: 0123456789 [MN] Manufacture ID: 31 34 65 34 [RV] Reserved: checksum bad, 26 byte(s) reserved Read/write fields: [YA] Asset tag: XYZ01234567 [RW] Read-write area: 107 byte(s) free End Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+ Address: fa7fb52dac9a6bfc Data: a20a Kernel driver in use: tg3 Kernel modules: tg3