Modem will not respond in Efax-gtk or in Minicom after initialization.
This modem works fine in Windoze, SAME machine, just switched to Ubuntu 12.04 drive by mechanical switch. I can go back and forth, always works in Windoze, never in Ubuntu.
Modem will attempt to answer an incoming call, but can't be sure about function since I don't have another modem to call with.
IN MINICOM :
Welcome to minicom 2.5
Compiled on May 2 2011, 10:05:24.
Press CTRL-A Z for help on special keys
Nothing further will be shown, no matter what keyboard input, etc. - except it will respond to CTL-A and Z, which are not modem responses
IN EFAX-GTK :
efax-0.9a: 21:27:23 opened /dev/ttyS4
)Then try to send and wait 5 minutes - no result, so press "Stop")
*** Stopping send/receive session ***
efax-0.9a: 21:27:46 failed page /home/roger/Documents/Libre Office/Saddleback Labs Request.pdf.001
MODEM INFO :
description: PCI bridge
product: Integrated Technology Express, Inc.
vendor: Integrated Technology Express, Inc.
physical id: 0 bus info: pci@0000:03:00.0
version: 30 width: 32 bits clock: 33MHz
capabilities: pci pm subtractive_decode bus_master cap_list
description: Serial controller product: 56K FaxModem Model 5610
vendor: 3Com Corp, Modem Division
physical id: 1 bus info: pci@0000:04:01.0
version: 01 width: 32 bits clock: 33MHz
capabilities: pm 16550 cap_list
configuration: driver=serial latency=0
resources: irq:17 ioport:d000(size=8)
roger@roger-desktop:~$ sudo wvdialconf
[sudo] password for roger:
Scanning your serial ports for a modem.
Modem Port Scan<*1>: S0 S1 S2 S3
ttyS4<*1>: ATQ0 V1 E1 -- failed with 2400 baud, next try: 9600 baud
ttyS4<*1>: ATQ0 V1 E1 -- failed with 9600 baud, next try: 115200 baud
ttyS4<*1>: ATQ0 V1 E1 -- and failed too at 115200, giving up.
Modem Port Scan<*1>: S5 S6 S7 S8
Modem Port Scan<*1>: S9 S10 S11 S12 S13 S14 S15 S16
Modem Port Scan<*1>: S17 S18 S19 S20 S21 S22 S23 S24
Modem Port Scan<*1>: S25 S26 S27 S28 S29 S30 S31
Sorry, NO MODEM WAS DETECTED! Is it in use by another program? - (my caps)
Did you configure it properly with setserial?
OK, so Ubuntu finds the modem, but doesn't find it !?!?!? Which is correct ?!?
I am a member of dialout group and all others I could think of that might affect this
I'm almost ready to believe it's a kernel problem, except not by intent. I can't imagine anyone would intentionally screw that up thinking it's best for the world...
I'm NOT trying to connect to an ISP right now, I want to use it with eFax-GTK.
It worked on 12.04 before one of the later updates which included Ubuntu segments as well as others. Then it just quit...