WIFI won't work after reinstall.
ok i got a silly little netbook to carry movies around on, had 12.04 on it lost the password (fiances fault) and so i reinstalled 12..04, wifi worked before no problem, iv been searching all the threads and i can't find a solution that helps me anywhere, The netbook is a COBY 10 inch netbook PC
dmesg | grep rt2
[ 530.005553] rt2800pci 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 530.005577] rt2800pci 0000:02:00.0: setting latency timer to 64
[ 530.062753] Registered led device: rt2800pci-phy0::radio
[ 530.062850] Registered led device: rt2800pci-phy0::assoc
[ 530.062933] Registered led device: rt2800pci-phy0::quality
[ 530.204837] phy0 -> rt2800pci_mcu_status: Error - MCU request failed, no response from hardware
stice@stice-laptop:~$
this is what i get, nothing comes up when i type rfkill list all, and my hard toggle doesnt change a thing it's Fn + F1 , as previousl;y mentioned though it worked fine before now it doesnt work at all, please help and thanks in advance.
Re: WIFI won't work after reinstall.
Please post the output of
and
Re: WIFI won't work after reinstall.
00:00.0 Host bridge: Intel Corporation N10 Family DMI Bridge
00:02.0 VGA compatible controller: Intel Corporation N10 Family Integrated Graphics Controller
00:02.1 Display controller: Intel Corporation N10 Family Integrated Graphics Controller
00:1b.0 Audio device: Intel Corporation N10/ICH 7 Family High Definition Audio Controller (rev 02)
00:1c.0 PCI bridge: Intel Corporation N10/ICH 7 Family PCI Express Port 1 (rev 02)
00:1c.1 PCI bridge: Intel Corporation N10/ICH 7 Family PCI Express Port 2 (rev 02)
00:1d.0 USB controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #1 (rev 02)
00:1d.1 USB controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #2 (rev 02)
00:1d.2 USB controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #3 (rev 02)
00:1d.3 USB controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #4 (rev 02)
00:1d.7 USB controller: Intel Corporation N10/ICH 7 Family USB2 EHCI Controller (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev e2)
00:1f.0 ISA bridge: Intel Corporation NM10 Family LPC Controller (rev 02)
00:1f.2 IDE interface: Intel Corporation N10/ICH7 Family SATA Controller [IDE mode] (rev 02)
00:1f.3 SMBus: Intel Corporation N10/ICH 7 Family SMBus Controller (rev 02)
01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 02)
02:00.0 Network controller: Ralink corp. RT3090 Wireless 802.11n 1T/1R PCIe
lo no wireless extensions.
eth0 no wireless extensions.
Re: WIFI won't work after reinstall.
Hi, follow the instructions in this post.
Re: WIFI won't work after reinstall.
ok tried to no effect, i probably put them in the wrong place in gedit or some such but its still not working at all.
Re: WIFI won't work after reinstall.
Well, we can check that. Please post output of
Code:
cat /etc/modprobe.d/blacklist.conf
Also, did you reboot after running those commands?
Re: WIFI won't work after reinstall.
Code:
# This file lists those modules which we don't want to be loaded by
# alias expansion, usually so some other driver will be loaded for the
# device instead.
blacklist rt2800pci
blacklist rt2800lib
blacklist rt2x00pci
blacklist rt2x00lib
# evbug is a debug tool that should be loaded explicitly
blacklist evbug
# these drivers are very simple, the HID drivers are usually preferred
blacklist usbmouse
blacklist usbkbd
# replaced by e100
blacklist eepro100
# replaced by tulip
blacklist de4x5
# causes no end of confusion by creating unexpected network interfaces
blacklist eth1394
# snd_intel8x0m can interfere with snd_intel8x0, doesn't seem to support much
# hardware on its own (Ubuntu bug #2011, #6810)
blacklist snd_intel8x0m
# Conflicts with dvb driver (which is better for handling this device)
blacklist snd_aw2
# causes failure to suspend on HP compaq nc6000 (Ubuntu: #10306)
blacklist i2c_i801
# replaced by p54pci
blacklist prism54
# replaced by b43 and ssb.
blacklist bcm43xx
# most apps now use garmin usb driver directly (Ubuntu: #114565)
blacklist garmin_gps
# replaced by asus-laptop (Ubuntu: #184721)
blacklist asus_acpi
# low-quality, just noise when being used for sound playback, causes
# hangs at desktop session start (Ubuntu: #246969)
blacklist snd_pcsp
# ugly and loud noise, getting on everyone's nerves; this should be done by a
# nice pulseaudio bing (Ubuntu: #77010)
blacklist pcspkr
# EDAC driver for amd76x clashes with the agp driver preventing the aperture
# from being initialised (Ubuntu: #297750). Blacklist so that the driver
# continues to build and is installable for the few cases where its
# really needed.
blacklist amd76x_edac
Re: WIFI won't work after reinstall.
Don't know that it will make any difference at all but you should copy the block you added into the end of the file- make it look like this:
Code:
# This file lists those modules which we don't want to be loaded by
# alias expansion, usually so some other driver will be loaded for the
# device instead.
# evbug is a debug tool that should be loaded explicitly
blacklist evbug
# these drivers are very simple, the HID drivers are usually preferred
blacklist usbmouse
blacklist usbkbd
# replaced by e100
blacklist eepro100
# replaced by tulip
blacklist de4x5
# causes no end of confusion by creating unexpected network interfaces
blacklist eth1394
# snd_intel8x0m can interfere with snd_intel8x0, doesn't seem to support much
# hardware on its own (Ubuntu bug #2011, #6810)
blacklist snd_intel8x0m
# Conflicts with dvb driver (which is better for handling this device)
blacklist snd_aw2
# causes failure to suspend on HP compaq nc6000 (Ubuntu: #10306)
blacklist i2c_i801
# replaced by p54pci
blacklist prism54
# replaced by b43 and ssb.
blacklist bcm43xx
# most apps now use garmin usb driver directly (Ubuntu: #114565)
blacklist garmin_gps
# replaced by asus-laptop (Ubuntu: #184721)
blacklist asus_acpi
# low-quality, just noise when being used for sound playback, causes
# hangs at desktop session start (Ubuntu: #246969)
blacklist snd_pcsp
# ugly and loud noise, getting on everyone's nerves; this should be done by a
# nice pulseaudio bing (Ubuntu: #77010)
blacklist pcspkr
# EDAC driver for amd76x clashes with the agp driver preventing the aperture
# from being initialised (Ubuntu: #297750). Blacklist so that the driver
# continues to build and is installable for the few cases where its
# really needed.
blacklist amd76x_edac
blacklist rt2800pci
blacklist rt2800lib
blacklist rt2x00pci
blacklist rt2x00lib
Re: WIFI won't work after reinstall.
nope did nothing sadly, it worked fine before the update but nothing is working fter :( sad face lol
Re: WIFI won't work after reinstall.
Hi, now run
Code:
sudo modprobe rt2860sta
Then see if the wireless fires up.