Re: wlan/ether bridge setup
I autoreply to my question:
The solution to the filtering between eth1 and wlan0 (bridged together) can be found on the linux foundation bridge FAQ
http://www.linuxfoundation.org/colla...ARP_and_STP.29
No traffic gets trough (except ARP and STP)
Your kernel might have ethernet filtering (ebtables, bridge-nf, arptables) enabled, and traffic gets filtered. The easiest way to disable this is to go to /proc/sys/net/bridge. Check if the bridge-nf-* entries in there are set to 1; in that case, set them to zero and try again.
# cd /proc/sys/net/bridge
# ls
bridge-nf-call-arptables bridge-nf-call-iptables
bridge-nf-call-ip6tables bridge-nf-filter-vlan-tagged
# for f in bridge-nf-*; do echo 0 > $f; done