PDA

View Full Version : [ubuntu] Aircrack-ng and RT2500 Problem



colsandurz
April 28th, 2008, 10:10 PM
Hi I am trying to crack a WEP enabled server as part of a project for an electrical engineering course.

I am trying to use the aircrack-ng suite, however I am having a problem with my ralink card:


devin@devin-laptop:~$ sudo airmon-ng start wlan0 6


Interface Chipset Driver

wlan0 Ralink 2500 PCI rt2500pci - [phy0]/usr/sbin/airmon-ng: 833: cannot create /sys/class/ieee80211/phy0/add_iface: Directory nonexistent
Error for wireless request "Set Mode" (8B06) :
SET failed on device mon0 ; No such device.
mon0: ERROR while getting interface flags: No such device

(monitor mode enabled on mon0)




devin@devin-laptop:~$ sudo airmon-ng check


Found 7 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!

PID Name
4831 NetworkManager
4845 NetworkManagerD
4878 avahi-daemon
4879 avahi-daemon
4993 dhcdbd
5721 wpa_supplicant
5749 dhclient
Process with PID 5749 (dhclient) is running on interface wlan0



devin@devin-laptop:~$ ifconfig
wlan0 Link encap:Ethernet HWaddr 00:13:d3:75:d8:62
inet addr:192.168.1.123 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::213:d3ff:fe75:d862/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4184 errors:0 dropped:0 overruns:0 frame:0
TX packets:2233 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2538252 (2.4 MB) TX bytes:349931 (341.7 KB)
Note: I cut out my other interfaces.

I've looked around and found that some places call for new drivers, but I haven't been able to figure what driver I need to use exactly. However, I think I just need to disaable some of those processses in the second command I've shown. If it's that simple... how do I disable(not remove) those processes.

I would really appreciate any help.

colsandurz
April 28th, 2008, 10:33 PM
http://www.aircrack-ng.org/doku.php?id=rt2500

I seemed to have found the problem and the solution here.... but I have different questions now.

1) How do I find out what driver I am using now?
2) How can I switch between these drivers?

Thanks again