PDA

View Full Version : [SOLVED] kubuntu showing 2 different nework speeds (wired)



skreamz
September 14th, 2011, 11:55 AM
Hi, it seems I can only connect at 10mb which the networking interface is showing but when I type

ethtool eth0

it shows the following

Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Link partner advertised pause frame use: No
Link partner advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes

which says I'm connected at 100 mb I'm guessing the network interface is the correct one, as I have tested the speed, how would I set it at least to 100?

thank in advance.

http://www.4freeimagehost.com/show.php?i=1296052e12ac.png
http://www.4freeimagehost.com/resized/1296052e12ac.png (http://www.4freeimagehost.com/show.php?i=1296052e12ac.png)


managed to solve this by installing the drivers from the realtek website.