Led Sama
May 1st, 2011, 09:41 PM
Dear all,
I'm an electronic engineer from Peru, and some days ago I've changed some PC/104 boards in an anesthesia machine. The thing is that now I have one PC/104 for me free to use, but it has a DOS program that was designed to work as the user interface for the anesthesia machine that I mention before.
I really don't know how to configure it, I was thinking on checking the IP of the board an connect to a LAN to perform the ssh commands and instal ubuntu there, but so far I didn't find the IP addres for my PC/104 board, and when I check the files of the DOS program that runs in the board I could'nt find a DSOCK.CFG or something like that, were I can check the IP or enable networking in my board.
Another question, my board has an IDE connector, I think I'll connect a CD reader and install an operative system from source. I also have a CD with drivers for this board.
Any advice will help,
Thanks in advance.
I'm an electronic engineer from Peru, and some days ago I've changed some PC/104 boards in an anesthesia machine. The thing is that now I have one PC/104 for me free to use, but it has a DOS program that was designed to work as the user interface for the anesthesia machine that I mention before.
I really don't know how to configure it, I was thinking on checking the IP of the board an connect to a LAN to perform the ssh commands and instal ubuntu there, but so far I didn't find the IP addres for my PC/104 board, and when I check the files of the DOS program that runs in the board I could'nt find a DSOCK.CFG or something like that, were I can check the IP or enable networking in my board.
Another question, my board has an IDE connector, I think I'll connect a CD reader and install an operative system from source. I also have a CD with drivers for this board.
Any advice will help,
Thanks in advance.