eynestyne
October 18th, 2010, 03:27 AM
OK.. this section of the forum is littered with stuff about the Broadcom 4311. Well I have one of these and its making me sweat!
I can install the drivers, STA, fw-cutter, ndiswrapper. I have tried all and got them to work - but only for a short while. They all knock out after a few minutes. When it knocks out the blue light for the card stays on, but there is a red X or something where the network should be. Also no networks are detected. if i restart it works for a few more minutes and knocks out again.
Am i missing somethings?
Anyone have any ideas as to whats going on?
Thanks
I can install the drivers, STA, fw-cutter, ndiswrapper. I have tried all and got them to work - but only for a short while. They all knock out after a few minutes. When it knocks out the blue light for the card stays on, but there is a red X or something where the network should be. Also no networks are detected. if i restart it works for a few more minutes and knocks out again.
Am i missing somethings?
Anyone have any ideas as to whats going on?
Thanks