new adapter / new problem

[arolfsen]

I recently picked up a belkin f5d7050b

I know that It is working as the network icon in the applications bar at the top shows my network. for whatever reason I can't seem to connect to the network however. every time i click on it, it says network disconnected. thoughts?

[Iowan]

Post ifconfig -a and sudo lshw -C network

[arolfsen]

ifconfig -a:

eth0 Link encap:Ethernet HWaddr 00:0b:cd:a6:7c:77
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0(0.0b) TX bytes:0 (0.0b)
interrupt:10 base address:0xa000

lo Link encap:Local Loopback
inet addr: 127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX Packets:4 errors:0 dropped:0 overruns:0 frame:0
TX Packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:240 (240.0b) TX bytes:240 (240.0b)

wlan3: Link encap:ethernet HWaddr 00:22:75:4f:7e:97
inet6 addr: fe80::222:75ff:fe4f:7e97/64 scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX Packets:0 errors:0 dropped:0 overruns:0 frame:0
TX Packets:10 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0b) TX bytes:2016 (2.0kb)

wmaster0 Link encap:UNSPEC HWaddr:00-22-75-4f-7e-97-34-66-00-00-00-00-00-00-00-00
UP RUNNING MTU:0 Metric:1
RX Packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX Bytes:0 (0.0b) TX bytes:0 (0.0b)

[arolfsen]

sudo lshw -C network:

*-network
Description: ethernet interface
product: DP83815 (macphyter) ethernet controller
vendor: National Semiconductor Corporation
physical id: 12
bus info: pci@0000:00:12.0
logical name: eth0
version: 00
serial: 00:0b:cd:a6:7c:77
size: 10mb/s
capacity:100mb/s
width: 32 bits
clock: 33MHZ
capabilities: pm bus_master cap_list rom ethernet physical tp mii fibre 10bt 10bt -fd 100bt - fd autonegiation
configuration: autonegotiation=on broadcast=yes driver=natsemi driverversion=2.1 duplex=half latency=90 link=no maxlatency=52 mingnt=11 multicast=yes port=twisted pair speed=10mb/s
resources: irq:10 ioport:2400(size256) memory:d0004000-d0004fff memory:24000000-2400ffff(prefetchable)

*-network
description: Wireless Interface
physical id:2
logical name: wlan3
serial: 00:22:75:4f:7e:97
capabilities: ethernet physcial wireless
configuration: broadcast=yes multicast=yes wireless=IEEE 802.11bg

[Iowan]

I found a few other threads, but they were all pretty old. This (http://ubuntuforums.org/showthread.php?t=484976) was the most recent.
Was that all the lshw info - it looks a little short...

[arolfsen]

yep. that was all that showed up