View Full Version : help insatlling ZTE 636 HSDPA on Ubuntu 9.10

November 4th, 2009, 04:57 PM
Dear Ubuntu experts

Im trying to install ZTE 636HSDPA on my Toshiba laptop, I red too much on this forum and I treid too much but nothing.

I already did this

sudo gedit /etc/usb_modeswitch.conf

to delete the # and ; infront of ZTE 636 configuration lines

i did this command

sudo /usr/sbin/usb_modeswitch -W -c /etc/usb_modeswitch.conf

to change 19d2:2000 to 19d2:0031 by using the comand lsusb

so far so good.

i did this command to make this file
sudo gedit /usr/share/hal/fdi/information/20thirdparty/20-zte-mf626.fdi

and fill it with

<!-- -*- SGML -*- -->
<deviceinfo version="0.2">
<!-- ZTE MF626 HSDPA USB Modem -->
<match key="@info.parent:usb.vendor_id" int="0x19d2">
<match key="@info.parent:usb.product_id" int="0x0031">
<match key="@info.parent:usb.interface.number" int="3">
<append key="modem.command_sets" type="strlist">GSM-07.07</append>
<append key="modem.command_sets" type="strlist">GSM-07.05</append>
<append key="info.capabilities" type="strlist">modem</append>

so far so good

i did this command to create this file

sudo gedit /etc/udev/rules.d/90-zte.rules

and fill it with the following configuration

ACTION!="add", GOTO="ZTE_End"

SUBSYSTEM=="usb", SYSFS{idProduct}=="2000", SYSFS{idVendor}=="19d2", GOTO="ZTE_ZeroCD"

RUN+="/usr/sbin/usb_modeswitch -W -c /etc/usb_modeswitch.conf"


i created the file ttyUSB by it is command

for the wvdial.conf i found many configurations and i used this conifguration

[Dialer Default]
Modem= /dev/ttyUSB0
Modem Tybe = Analog Modem
ISDN = 0
New PPPD = yes
Baud = 9600
Username = user
Password = pass
Phone = *99#
Stupid Mode =1
Init1 = ATZ
nit2 = AT&Q0 V1 W1 S0=0 &C1 &D2 +FCLASS=0
Init3 =AT+CGDCONT=1,"IP", "internetg"

when i run the wvdial by the command sudo wvdial i get this answer

command not found

and the system can not connect with the modem



Thank u very mcuh