Nips_
July 25th, 2009, 08:32 PM
Hi All,
Please excuse this question if it is a bit simple - I'm a bit of a newbie to Linux.
Just install Ubuntu 9.04. All went well except that my Nic will only connect at 100MB (at lease that is according to "Connection Information".
Have tried using ethtool to force it, but it only seems to think it can go to 100MB. Have been searching for updated drivers but cannot find any that will compile - make all complains of undefined identifiers.
Currently still set up to dual boot WinXP - if I boot into XP, GB works fine.
The card is a Mecer branded card using the IC Pluss IP1000 Chip. "Connection Information" reports it as "Sundance Technology IPG Triple-Speed Ethernet"
Any advice?
Thanks
Nips
Please excuse this question if it is a bit simple - I'm a bit of a newbie to Linux.
Just install Ubuntu 9.04. All went well except that my Nic will only connect at 100MB (at lease that is according to "Connection Information".
Have tried using ethtool to force it, but it only seems to think it can go to 100MB. Have been searching for updated drivers but cannot find any that will compile - make all complains of undefined identifiers.
Currently still set up to dual boot WinXP - if I boot into XP, GB works fine.
The card is a Mecer branded card using the IC Pluss IP1000 Chip. "Connection Information" reports it as "Sundance Technology IPG Triple-Speed Ethernet"
Any advice?
Thanks
Nips