PDA

View Full Version : [ubuntu] minicom settings



e24ohm
January 19th, 2009, 04:27 PM
forum,
I am trying to use minicom to connect to my cisco switch/router via the serial port.

what are the commands in minicom to set the buad rate, bits and all that good stuff?

I am lost.

thank you,
E

Kebabman
January 19th, 2009, 04:31 PM
To configure minicom you just need to type :

CTRL-A

followed by

Z

Then to get to the configuration type

O

Then go to serial port setup.

There is also a shortcut of just typing :

CTRL-A

followed by

O

Hope this helps

e24ohm
January 19th, 2009, 04:44 PM
To configure minicom you just need to type :

CTRL-A

followed by

Z

Then to get to the configuration type

O

Then go to serial port setup.

There is also a shortcut of just typing :

CTRL-A

followed by

O

Hope this helpsthanks mate i am going to try that.

e24ohm
January 19th, 2009, 04:45 PM
To configure minicom you just need to type :

CTRL-A

followed by

Z

Then to get to the configuration type

O

Then go to serial port setup.

There is also a shortcut of just typing :

CTRL-A

followed by

O

Hope this helpsthanks this is great.